Kafuter 50G K-0340 Anaerobic adhesive gasket cement Screw Gear Holding High strength temperature resistant | Обустройство дома

Kafuter 50G K-0340 Anaerobic adhesive gasket cement Screw Gear Holding High strength temperature resistant | Обустройство дома

K-0340 high-strength, for a variety of M20 the following thread locking and sealing, cylindrical parts and plugs Goodrich and other location. The product between close fitting metal surfaces and cured and air separation.

K-0340 (Universal / high intensity anaerobic adhesive) is a single component,thixotropic viscosity, high strength and resistance to medium fine anaerobic adhesive.This product is in close cooperation with the two metal surfaces, and air contact curing.

Product application:

General purpose, high strength, fast curing, suitable for sliding fitting fixing and sealing,bearing, gear, chain, such as technological hole plug fixed, fixed gap is less than or equal to 0.25mm. Typical use: screw locking and sealing, bearing locking.

The nature of the product:

The base material chemical composition of methyl acrylate

Appearance light yellow viscous liquid

Viscosity (mPa.s) of 300 ~ 600

The proportion of the 1.05

Flash point (c) > 108

Maximum gap fill (mm) 0.13

The curing time at room temperature (min) is less than or equal to 15

After curing performance:

Room temperature solid time (HR) 24

The shear strength of more than or equal to 10

Failure moment (N m) 20

The average removal torque (N m) 15

Working temperature (c) 54 ~ 149

Instructions for use:

- coated surface should be clean, dry and free of grease.

For sliding fit part, just around the axle and the sleeve guide angle of a painted circleassembly glue, turning around to ensure good coating.

For press fit, two the surface to be adhered, are required to be coated with glue, and assembly at high pressure presses on the appropriate.

For heat shrinkable mating parts, glue coated on the shaft, and then the heating sleeve generated enough clearance of free assembly.

And the assembled components never before did not reach enough strength to move.

The use of attention to matters:

The high intensity anaerobic adhesive should not be used in plastic parts; in order to avoid the pollution of raw glue, do not have poured glue back to the original package.

Safety precautions:

The high intensity anaerobic adhesive containing methacrylate, a stimulating effect on the skin and eyes. If the skin contact, immediately wash with water; if contact with eyes,rinse immediately with water and to a hospital for treatment.