BAND 3 FDD LTE 4G Booster 980 Power 30 Dbm Gain 65dbi LCD Display 1800mhz Mobile Phone Signal Repeater DCS 2G Enlarger | Мобильные

BAND 3 FDD LTE 4G Booster 980 Power 30 Dbm Gain 65dbi LCD Display 1800mhz Mobile Phone Signal Repeater DCS 2G Enlarger | Мобильные

******Important Note ( please read , and please read all descriptions carefully ) ************:
To let a booster work it needs conditions :

1. please be sure that signal outside of your house is good enough to enable booster to work , what good signal is:
a). stand there to check if you can make fluent call or not,if can ,then you buy ,otherwise please dont buy ;
b). Put your phone there to check its signal strengthness :
Android : setting-about phone-status-network ,dbm display shall be at -60dbm to -75dbm around ;
IOS : dial *3001#12345#*, dbm display shall be at -60dbm to -75dbm around ;

-80dbm to -100dbm means bad,so please dont buy

2. Please be sure the place where you are going to install is frequency 1800MHZ ( for 2G or for 4G ) ,operator use DCS1800mhz for 2G network, and use it for some 4G LTE , please check to clarify .

3. Buy correct cable and anteana ,50ohm cable is recommended ,RG58 not recommended , for DCS ,3G,4G you must use 50Ohm cable ;

4. Install them correctly to avoid interference ( auto osillation ) with walls between indoor & outdoor antenna, when interference exist ,LCD will display full signal bar or signal LED normal on, but phone can not make call .

For avoiding unhappiness ,please do not buy before you are clear about the above .

Before buy a 4G booster ,please check with operator to ask what bands ( frequency )  exactly they use for your area , because too many different frequency for 4G to use, even a same operator may now use same band ( frequency ) in different areas .

So please check it before buy to avoid wrong buy or complain lately by saying product not works ,because 4G is not as simple as 2G or 3G booster .

Details about different bands for 4G //en.wikipedia.org/wiki/List_of_LTE_networks

Selling point of product :

1.  Model 980  .
2.  Power : 30dbm ; gain : 65dbi ;
3. + 4G FDD LTE band 3;
4.  1800mhz booster;
5. OK simultaneously work for DCS 2G network and band 3 FDD 4G network ( eg. HK and other countries which use band 3 1800mhz for 4G ) ; Before buy please confirm that your country 4G is using this band
6. LCD display function to display signal receives.

mobile phone signal amplifier,cellphone repeater/booster

Detaileds:

Voltage :
110-220V AC to DC12V 2A

Frequency range : 

1710-1785 ( UPLINK  )
1805-1880 ( DOWNLINK )

Gain :

Uplink ≥60dBi         Donwlink ≥65dbi

Output power :  

                          Uplink:   30dbm

                          Donwlink :30dbm    

Outdoor signal strength request for outdoor antenna: at least -65dbm around ;

If you can have an android phone ,you can use it to test your signal strengthness as below :

For this product ,it will request signal strengthness not higher than -55dbm , if your signal strenght is worse to -55dbm ,it may work not good for you or not amplify signal for you .

PS.: -65 ,-70 and -80 dbm is worse signal than -60dbm ,-55dbm is better signal than -60dbm .

Impedance : 50Ω  ;
Seclusion  : >70db
Ambient temperature:-10oC--50oC

Power:   12V/ 2A prower

Size : 24*18.3*2cm
Net weight : 0.94kgs .

Gross Weight  :1.29Kg

Note :
The product does not include accessories of cable , Heads and antennas , you need to buy them extraly,it  only has power Adaptor included .

2.  The booster will have label DCS 1800mhz on ,not LTE FDD

Problems and solutions ( important ) , please read :

All booster will be tested before shipping to ensure quality , if you dont know any about booster and installation please start from 0 as below .

1. After power connected ,if LCD does not display or power LED is not on ,it means booster is defective ,kindly choose a friendly to solve it ,we accept to reship or refund. Andy dispute or negative will cause you on black list and an uncooperative solution ;

2. After you connet cables and antenna onto booster ,Lcd display 1-3 bars, you need to change your external antenna to a better place to gain stronger signal, if you use small pin antenna ,please upgrade it to a panel or a yagi ; If you can not find a place with good signal to enable booster with full bar display ,it means your outdoor signal is too bad ,booster will not work . So please kindly contact for a solution to return .

3. After you connet cables and antenna onto booster ,Lcd display full bar or signal LED is on ,but phone can not make call , it means big interference ( not booster quality problem ) which cause booster dead called auto osillation , so you need ( indoor and outdoor antenna can not see each other ) :
1). Use longer cable to enable outdoor antenna far away from booster and indoor antenna ;
2). Face outdoor and indoor antenna to different direction;
3). Get one or 2 walls between outdoor antenna and indoor antenna to ensure they are well insulated .
4). Check with your operator to ask what frequency are adopted in your area to ensure your booster matchs ( operator will use 900mhz in some area and use 1800mhz in an other area ) .

If you still can not solve it yourself , you can friendly talk choose return or refund,
any dispute or negative mean buyer bad !!

Below model ( IGC and ALC function ) may work under conditions :
1. bad outdoor signal at -80dbi to -85dbi around ;
2. No need wall to 100% insulate indoor and outdoor ( but if both antennas are too close ,it will not work too ) ,

http:/store/product/digital-display-gain-65dbi-Auto-Gain-Control-GSM-booster-GSM-repeater-900mhz-booster-mobile-phone-repeater/601777_2031233344.html

http:/store/product/digital-display-gain-65dbi-Auto-Gain-Control-GSM-booster-GSM-repeater-900mhz-booster-mobile-phone-repeater/601777_2031271457.html

http:/store/product/Auto-Gain-Control-GSM-booster-digital-display-gain-65dbi-GSM-repeater-GSM-900mhz-booster-kits-w/601777_2031465046.html

http:/store/product/Auto-Gain-Control-GSM-booster-digital-display-gain-65dbi-GSM-repeater-hone-booster-repeater-w-9/601777_2031466146.html

http:/store/product/Auto-Gain-Control-GSM-booster-digital-display-gain-65dbi-GSM-repeater-mobile-phone-repeater-w-9/601777_2031464919.html

http:/store/product/digital-display-gain-65dbi-Auto-Gain-Control-GSM-booster-GSM-repeater-mobile-phone-repeater-w-yagi/601777_2031271870.html

http:/store/product/Auto-Gain-Control-GSM-booster-digital-display-gain-65dbi-GSM-repeater-mobile-phone-repeater-w-yagi/601777_2031451606.html

Above models is only possible to work if outdoor signal is not good (-80dbm) ,does not mean 100% to work if really bad outdoor signal ( because a booster will take many conditions ) .

When you buy them it means that you just want to take try ,if does not work ,please be friendly to solve. If you are going to direct dispute or negative, please dont buy .